Accessories
Step-by-step guides for various tasks using Measurand Accessories.
The SAAV Cleat is an accessory that facilitates the installation of Measurand's SAAV and SAAV Extend instruments. The SAAV Cleat is a support tool desig...
Thu, 27 Apr, 2023 at 8:41 AM
Step 1 - Remove the Eyebolt from the SAAV Using an adjustable or 16mm (5/8") wrench, remove the eyebolt from the far end of the SAAV. This action w...
Tue, 7 Nov, 2017 at 9:58 AM
Measurand's SAAV Casing Cap includes two interchangeable collars designed to fit the most common sizes of inclinometer casings (70 mm and 85 mm). This g...
Fri, 26 May, 2017 at 11:27 AM
Measurand’s SAA Surge Protection Device (SAASPD) is designed specifically to protect a ShapeArray (SAA) from electrical surges caused by proximal lightning...
Tue, 5 Nov, 2019 at 4:14 PM
Each ShapeArray (SAA) comes with 15 m of communication cable attached. In cases where longer cables are required, splice kits will be needed to properly ex...
Mon, 6 Mar, 2023 at 12:13 PM
Introduction Figure 1: An SAASim Measurand’s SAA Simulator (SAASim) was designed and developed to provide a low cost accessory to verify Data Logge...
Mon, 19 Oct, 2020 at 3:11 PM
PEX tubing is used in ShapeArray (SAA) construction to protect the communication cable from damage and to provide a secure way of retrieving the ShapeArra...
Fri, 4 Aug, 2017 at 1:04 PM
Measurand's SAAV Casing Cap provides a simple, clean, and efficient way to complete an SAAV installation in standard inclinometer casings. The SAAV Casi...
Tue, 13 Feb, 2024 at 2:53 PM
The maximum cable lengths for SAA500-001 at 8.3 V are given in the table below. Use an approved splice kit to add any cable to an existing SAAV, and ensure ...
Fri, 21 Jul, 2023 at 5:57 PM
The maximum cable lengths for SAAX1000-002 at 8.3 V are given in the table below. Use an approved splice kit to add any cable to an existing SAAX, and ensur...
Fri, 21 Jul, 2023 at 3:52 PM